CZ test

[T300WSM]

Went to the range with my son today to try out the trigger kit I put in our CZ. After we took a few shots (the set up was very light) I told my son to try hitting the stock with the 1x6 trim end that was on the bench. As you can see in the vid he has a cast on his hand so he had some problems holding the 1x6. You can see how little impact it took to fire the gun.





After this test when we got home I changed the spring for the next heaver spring. We will go back tomorrow and check it out again.

[lineofsight]

That the YoDave kit?
Did you start with the lightest spring?
Did you also shim the trigger pin?

Its on my to do list for a 452 Lux.

[T300WSM]

Yes it is the YoDave kit, I did start with the lightest spring, it is very light about 4 times lighter than the stock spring. I did shim the trigger pin with the larger of the suppied shims in the kit. The stock trigger pin had a bend in it that would have give it more trigger creep. The kit did take out the trigger creep but it is to soft now. will see how it is with the next spring. I will also do the bump test again.